1. Overview
1.1 Product Feature
●
●
●
Compliance with IEEE 802.11g and 802.11b standards
Highly efficient design mechanism to provide unbeatable performance
Achieving data rate up to 54Mbps for 802.11g and 11Mps for 802.11b with
wide range coverage; high performance to deliver up to 108Mbps raw data
rate for 802.11g
●
●
Strong network security with WEP and 802.1X encryption
Quick and easy setup with Web-based management utility.
1.2 System Requirements
●
Windows 98, 98SE, Millennium Edition (ME), 2000 and XP operating
systems
●
●
●
Microsoft Internet Explorer 5.5 or higher
One CD-ROM drive
At least one RJ-45 Ethernet network adapter installed.
1
2. Getting Start
2.1 Know the 108Mbps Wireless Network Access Point
Ports:
●
●
●
Power Receptor
Reset Button
RJ-45 Ethernet Port
LEDs:
●
●
●
Power LED: ON when the unit is powered up
LAN LED: ON indicates LAN connection; BLINK indicates LAN activity
WLAN LED: ON indicates WLAN is working; BLINK indicates wireless
activity.
2.2 Connect to the 108Mbps Wireless Network Access Point
Build the Infrastructure Mode
2
In order to setup an Infrastructure of a wireless network such as the example
shown above, you will need the following:
1. A broadband Internet connection.
2. ADSL or Cable modem provided by your ISP as part of the broadband
connection installation.
3. A Router that connects to the ADSL/Cable modem for Internet connection
sharing.
4. An Access Point to connect with the Router to form a wireless infrastructure
network.
5. Wireless clients equipped with wireless networking devices such as wireless
PC Card for wireless connection.
2.3 Quick Setup with Wizard
2.3.1
Access the Setting Menu
You could start to access the configuration menu anytime by opening a web
browser window by typing the IP address of this access point. The default IP is
192.168.1.1.
3
|